How to Use Plasma Cutters Safely and Effectively Plasma cutting is a precious tool for getting fast, neat cuts in steel, aluminum, or stainless. This is possible through the use of plasma cutters that fuse a high-pressure air or gas flow with an electric arc. The heat may go up to a temperature of up to 40,000 degrees Fahrenheit. Below are some things to keep in mind while using a plasma cutter: Safety Above All While plasma cutting is not as intense as welding, you have to proceed as though it is. Make it a point to wear flame-retardant clothes and hair covering. Put on glasses #5 eye protection and work in a safe location. Know your surroundings. Keep in mind that the heat and light can be strong, and you have to ensure your safety.
What Research About Equipment Can Teach You
Consumables
What Research About Equipment Can Teach You
If you notice that your cuts have lost their sharpness, you may have to get new parts that make up the cutting head. Usually, this could consist of a heat shield, contact tip, insulators, nozzle, and offset tool. It’s essential that you check the availability of such consumables when you buy your plasma cutter. Select a current model with a convenient process for ordering parts. The Importance of Moisture To work efficiently, plasma cutters require clean, dry air. Moisture is the main cause of parts turning bad. There are some things you can do to decelerate the effects of moisture, and control it to a bare minimum. Provide 25 to 30 feet of line between the moisture trap and from the air compressor. The moisture trap is going to work better if the air can cool first. You can get an air drier that utilizes silica gel to attract moisture from the air. In fact, get two – they are affordable. These could be installed at the compressor and at the water trap to stretch the life of your consumables. The air driers themselves are easier and less expensive to replace than the plasma cutter parts. Cutting Speed You should cut at the effective speed. If you’re new to plasma cutting, it could take you a few attempts to get it dialed in well. Among the best signs is the direction of the sparks while you’re cutting. When cutting too fast, the sparks move towards you. You should take it slow. The sparks and dross should go towards the floor. The Angle Usually, you will be holding the plasma cutter at a 90-degree angle to whatever you are cutting. Reaching the end of a cut, pull the angle up a bit to make for a beautifully smooth end of cut. If there’s some dross on your cut’s underside, a small file should take care of that pretty well.